![]() Log: awslogs etwlogs fluentd gelf json-file logentries splunk syslog Network: ics l2bridge l2tunnel nat null overlay transparent If I use the container ip then it works just fine. I would like to be able to access it via chrome on i can see the container is starting and output is written in the console but windows i can’t get a site using localhost. and would like to connect to it via localhost.ĭocker run -d -p 8000:80 -name demo microsoft/dotnet-samples:aspnetapp_ You should verify your routing settings on the local host to resolve this situation.I’m trying torun a windows container on my windows machine. This can result if the default gateway is not configured correctly. It is possible that the LAN host does not know how to reach the IP address of the Internet client. There is an incorrect route configured on the LAN host. We recommend consulting with the particular client’s manufacturer for more information. On Linux machines, this could be a result of the connection not being allowed in the iptables firewall. On Windows computers, this may be a result of the Windows Firewall rules. In this case, the host/server on the LAN is not allowing outside connections to access the port. The LAN host is blocking the port with a local firewall, or does not have the correct route configured. We recommend disabling any upstream firewalls for testing, and then contacting your ISP for more details. In this case, the traffic is most likely blocked somewhere upstream, such as at the ISP modem/router, or a third party firewall. Incoming traffic is not reaching the WAN interface of your UniFi Gateway. page URL if this is a docs issue or the name of a man page. a reproducible case if this is a bug, Dockerfiles FTW. Try disabling UPnP in your UniFi Network Application’s Internet Settings. Diagnostic ID from 'Diagnose & Feedback' in the menu. Note: If you dont see Map network drive on the More menu, you can right-click the This PC node in the folder pane and youll see the command there. ![]() Then, on the File Explorer ribbon, select More > Map network drive. Note: It is possible to forward multiple WAN ports to the same LAN port.Īnother possible cause is that UPnP is enabled and is already using the port. Open File Explorer from the taskbar or the Start menu, or press the Windows logo key + E. For example, TCP port 443 can only be forwarded to one LAN port. Your UniFi Gateway is already forwarding the port to another device or has UPnP enabled.Ī given WAN port can only be forwarded to a single device within your network. You may wish to contact your ISP to assist with port forwarding or providing a DMZ option that allows you to automatically forward the ports. If that is not supported, you will need to first forward the port(s) on the upstream router/modem to the WAN address of your UniFi Gateway in addition to forwarding them from your UniFi Gateway to the desired location. To fix this issue, try to re-configure your ISP modem/router into bridge mode so that your UniFi Gateway can obtain a public IP address on the WAN interface. Once the container is up and running, type ipconfig to view the IP details. 80(right hand side) Destination port Map the container port. You are likely affected by this if your UniFi Gateway has a WAN IP address in one of the following ranges: This happens if your UniFi Gateway is located behind another router/modem that uses NAT. Your UniFi Gateway does not have a public IP address (Double NAT). Refer to the troubleshooting steps below if your Port Forwarding or custom Destination NAT rule is not working. Create Port Forwarding rules within UniFi Network in the Settings > Firewall & Security section.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |